NF ZM2376 - Displays and Indications at Power ON

3.2 Display at Power “ON” and Initial Settings
3-5 ZM2376
3.2.2 Displays and Indications at Power “ON”
Take necessary steps before instrument usage/operation according to “2. PREPARATIONS
BEFORE USE”.
When the power switch is turned on, a test pattern is displayed, and then a starting message including
the model name and firmware version is displayed (see below).
Model name
Example: ZM2376
V1.00 2013/10/25 16:27
Version Last adjustment date and time
Also, all lamps light up. During this time, the self diagnosis is conducted. If an error is found, an
error message is displayed.
For details  “5.1.1 Errors at Power ON’’
If a serious error is found, the device will no longer operate with an error message displayed.
When a setting or correction value has been lost, an error message is displayed but the parameter for
which the error occurred is initialized and started. This error message can be reset by pressing any
key.
Initialization contents  “3.2.3 Initialization”
The settings and correction values at the time when the power was turned off last are resumed unless
the resume memory that saves last settings is normal.