3.5 Basic Operations
3-19 ZM2376
3.5 Basic Operations
3.5.1 Outline of Measurement Screen
During the measurement, the measured value and main settings are displayed on the LCD display (40
characters x 2 lines) of the front panel. Basic contents of display are as shown below.
Measured value
Lp Ls Cp Cs Rp Rs Z Y G Q D θ X B Rs Rp G Lp Rdc
Primary parameters Secondary parameters Measurement frequency
Ls:+1.23456µH Q :+12.3456 1.00000M Hz
A100mΩ FAST256 Int OpShLd2m 0.000 1.00 V
1) 2) 3) 4) Vdc Vrms or Arms
Status (main settings: See below) DC bias Measurement signal level
1) RANGE: Measurement range
{Auto | Hold} and impedance measurement range
2) SPEED/AVERAGE: Measurement speed and averaging
{RAP | FAST | MED | SLOW | VSLO} and averaging count
3) TRIG SOURCE:
{Int | Man | Ext | Bus}
4) CORRECTION:
Op OPEN
Sh SHORT (Only the enabled corrections are displayed)
Ld LOAD
Xm Cable length {0m | 1m | 2m | 4m}
{ } indicates that either one of options delimited with | is displayed.
To Next Page
Loading...
