Nordmann Engineering AT4 D - Supply and Exhaust Fan Operation; Combined Fan Mode Settings

28
– Operation with supply and exhaust fan
In this operation mode a supply and an exhaust fan is connected to the Nordmann AT4 D.
Select “Fan” in the steam bath settings menu, then press the <Set> key. In the following display
select “Mode”, then press the <Set> key.
BathSettings
Fan :Set
Fragrance :Set
Light :Set
Operation :Panel
Sensor :Set
Esc Set
Settings
BathSettings:Set
Cylinder :4564
SC-System :Set
Language :English
Power Limit :100%
Esc Set
Fan
Mode :O
Esc Set
Mode
O
1-Fan
2-Fan
2-Fan
Esc Set
Fan
WhileBathing:Supply
While Light :On
Fan In :Set
Mode :2-Fan
Fan Out :Set
Esc Set
Fan
WhileBathing:Supply
While Light :On
Fan In :Set
Mode :2-Fan
Fan Out :Set
Esc Set
Fan
WhileBathing:Supply
While Light :On
Fan In :Set
Mode :2-Fan
Fan Out :Set
Esc Set
Fan
WhileBathing:Supply
While Light :On
Fan In :Set
Mode :2-Fan
Fan Out :Set
Esc Set
WhileBathign
O
Supply
Exhaust
Supply
BothFan
Esc Set
Drying Time
20 min
20 min
Esc Set
Drying Time
20 min
20 min
Esc Set
PrePurgeTime
2 min
2 min
Esc Set
PrePurgeTime
2 min
2 min
Esc Set
Fan
WhileBathing:Supply
While Light :On
Fan In :Set
Mode :2-Fan
Fan Out :Set
Esc Set
Bei Licht
Aus
Ein
Ein
Esc Set
While Light
O
On
On
Esc Set
Hysteresis
4 °C
4 °C
Esc Set
Hysteresis
4 °C
4 °C
Esc Set
Fan In
Drying Time :20min
Hysterese :4°C
PrePurgeTime:2min
Esc Set
Fan Out
Drying Time :20min
Hysteresis :4°C
PrePurgeTime:2min
Esc Set
Fan In
Drying Time :20min
Hysteresis :4°C
PrePurgeTime:2min
Esc Set
Fan Out
Drying Time :20min
Hysteresis :4°C
PrePurgeTime:2min
Esc Set
Fan In
Drying Time :20min
Hysteresis :4°C
PrePurgeTime:2min
Esc Set
Fan Out
Drying Time :20min
Hysteresis :4°C
PrePurgeTime:2min
Esc Set