Nordson Encore Series User Manual

Repair
6-8
Part 1612500−02
E 2018 Nordson Corporation
8. See Figure 6-7, View C. Pull the cable connectors out of the bottom of
the handle. Disconnect the power supply connector from the gun cable
connector by inserting a small flat-bladed screw driver in the slot of the
power supply connector to release the catch.
9. Carefully disconnect the round trigger connector from the trigger switch
connector.
10. Pull the cable out of the handle base, feeding the connectors through
the base one at a time.
27
31B
39
32
25
27
Trigger
Power Supply
Ground
VIEW A
VIEW B
VIEW C
26
Figure 6-7 Cable Replacement
25. M3 x 6 screw
26. M3 lock washer
27. Ground pad
31B. M3 x 20 screws
32. E-ring
39. Handle base

Nordson Encore Series Specifications

General

Maximum Output Voltage	100 kV
Power Source	Electric
Maximum Powder Output	20 lbs/hr (9.07 kg/hr)
Air Consumption	10-15 CFH (4.7-7.1 L/min)
Application	Powder coating
Technology	Electrostatic
Maximum Flow Rate	20 lbs/hr (9.07 kg/hr)
Weight	1.5 lbs (0.68 kg)