Notifier NFS-640 Programming Manual

2. Program Change How to Use the Basic Program
26
NFS-640 Programming Manual P/N 51333:B 10/03/2003
How to Change a Password (3=PASSWD)
Password Change lets you select a custom Program Change (high level) or Status
Change (low level) password. From the “Basic Program” screen, press the 3 key
to display the “Change Password” screen.
.
To change a password, follow the instructions below:
A Forgotten Password?
If a password is entered incorrectly, the panel will respond by displaying an
INCORRECT PASSWORD
message and a code. The programmer may hit escape and reenter the password correctly. However, if
the password has been forgotten, record the code and contact Notifier. After proper authentication, the
original password can be determined by deciphering the code. An example of an
INCORRECT PASSWORD
display is given below:
To Pres s Th e n
Change the Program Change
password
Enter the new Program Change
password. Use five digits, no characters.
Change the Status Change
password
Enter the new Status Change password.
Use five digits, no characters.
Save the password The Verify Password screen appears.
Press
ENTER to verify.
Leave the Change Password screen
without changing a password
The Basic Program screen appears.
Program Change
Password
CHANGE PASSWORD *,NNNNN,E=PROGRAM
#,NNNNN, E=STATUS
Entry area for new password
INCORRECT PASSWORD
PROGRAM: 9066-21F5-7D78-5FA4-6163
Code
www.PDF-Zoo.com

Notifier NFS-640 Specifications

General

Brand	Notifier
Model	NFS-640
Category	Fire Alarms
Language	English