74 Rev 2.3 • 14 Oct 08
5. Operation
Third-Party Router Control Systems
NVISION’s technical staff and with the supplier of the third-party equipment when integrating it
into an NV9000 control system.
Third-Party Router Control Systems
NV5128 control cards use a default protocol. However, at the timing or ordering, a number of third-
party control protocols can be installed upon request.
NVISION provides assistance to users wanting to configure NVISION products to function with
third-party control systems. However, because NVISION does not manufacture or warrant control
systems from other vendors, we cannot guarantee overall performance or answer all possible con-
figuration-related questions. For assistance, contact the manufacturer of the control system in use.
In many cases, router features and functionality are limited when using a third-party control sys-
tem. For example, the third-party system may not optimally manage mono routing, while the
NV9000 control system easily manages this function.
Please consult with NVISION if you are considering using a third-party interface to control an
NV5128 router. (See Technical Support Contact Information
on page iii.)
To Next Page
Loading...