NXP Semiconductors MPC5777M - Page 167

Document revision history
MPC5777M Microcontroller Data Sheet, Rev. 6
NXP Semiconductors 167
5 6/2015
Ordering Information
Table 75 (Orderable part number summary)
• Revised ED footnote (“‘ED’ refers to . . .”).
6 6/2016
Introduction
Section 1.3, Device feature
• Changed the name of the section to Device feature.
• Table 1 (MPC5777M feature) Changed the name of the table to MPC5777M feature.
Figure 1
• Removed the 50 MHz from the concentrator box and added 50 MHz and 100 Mhz to
the connection arrows.
Electrical characteristics—I/O pad specification
Section 3.7, I/O pad current specification
• Added paragraph (In order to ensure device reliability....., and In order to ensure device
functionality....).
• Removed the entries I
RMS_SEG
and I
DYN_SEG
in Table 19 (I/O consumption).
Table 12 (I/O input DC electrical characteristics)
•V
HYSTTL
specification: Changed min value to 0.275 V (was 0.250 V)
Electrical characteristics—Oscillator and FMPLL
Table 25 (Internal RC Oscillator electrical specifications)
• Added f
TRIM
specification.
Electrical characteristics—ADC Specifications
Table 28 (SDn ADC electrical specification),
•Z
DIFF
, Z
CM
and V
INTCM
specifications added. R
BIAS
specification has been updated.
Electrical characteristics—AC specifications—FlexRay
Table 66 (RxD input characteristics)
• Changed footnote (“FlexRay RxD timing is valid . . .”).
Table 76. Revision history (continued)
Revision Date Description of changes