NXP Semiconductors
AN13134
PN76 family evaluation board quick start guide
Figure 36. Build example
You can also choose the active build configuration by right-click on the project → Build Configurations → Set
Active → Debug/Release.
After the build finished, you will see 'Build Finished …' in the console.
Figure 37. Build finished successful
Now you can either flash or debug the build project.
AN13134 All information provided in this document is subject to legal disclaimers. © 2023 NXP B.V. All rights reserved.
Application note Rev. 2.5 — 2 May 2023
37 / 57
To Next Page
Loading...
