NXP Semiconductors
AN13134
PN76 family evaluation board quick start guide
Figure 40. Flash application
In case you want to flash another application you build you can do so by browsing to the .hex or .bin file at (see
"1"). The base address (see "2") is the start address of the user application space and shall not be changed.
Press "Run..." (see "3") to start the programming.
AN13134 All information provided in this document is subject to legal disclaimers. © 2023 NXP B.V. All rights reserved.
Application note Rev. 2.5 — 2 May 2023
40 / 57
To Next Page
Loading...
