OCULUS Corvis ST - Adjustments after an In-House Transport; Device Set-Up; Unlock Transport Safety Device

10 Start-up
18 / 80 Instruction Manual Corvis® ST (G/72100/XXXX/EN 1019 Rev01)
10.3 Adjustments after an in-house transport
Note
Equipment damage due to incorrect lifting
If the Corvis® ST is lifted only by the measure head, it can break off.
 Grab the Corvis® ST from below and the head rest to lift it.
10.3.1 Device set-up
 Place the Corvis® ST on a level surface.
 Place the Corvis® ST so that no direct light can effect the
measurement.
 Avoid shocks and vibration.
 Avoid contamination, high temperatures and humidity.
10.3.2 Unlock transport safety device
During transport the Corvis® ST is secured with a transport safety device.
This must be unlocked before use.
 Open the cover with the display.
Abb. 10-1: Open the cover with the display