EasyManuals Logo

OCULUS Corvis ST User Manual

OCULUS Corvis ST
86 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
14 Perform a measurement with the Corvis® ST unit
Instruction Manual Corvis® ST (G/72100/XXXX/EN 1019 Rev01) 51 / 80
Enter the date of birth and confirm with [Enter].
If you have entered the correction calculation per „Spoerl“ you must enter
the patient’s date of birth so that the correction is calculated correctly.
You will be asked if you want to save the new patient data.
Select "Yes".
The patient's name appears in the list.
Press the [Start] button to switch to measure mode, sec. 12.1,
page 31.
14.2.2 Select an existing patient
Choose a patient whose data is already stored, and whom you wish to
examine again.
In the Patient Data Management (fig. 14-1, page 49) menu, press the
[Patient List] button.
Turn the control knob to the desired entry in the list.
Press the control knob to select the desired patient.
Press the [New Exam/Back] button to switch to measure mode,
sec. 12.1, page 31.
Abb. 14-4: Patient list

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the OCULUS Corvis ST and is the answer not in the manual?

OCULUS Corvis ST Specifications

General IconGeneral
BrandOCULUS
ModelCorvis ST
CategoryMedical Equipment
LanguageEnglish

Related product manuals