OCULUS Corvis ST - Perform a Measurement; Setup and Adjustment for Measurement

12 Perform a Measurement
Instruction Manual Corvis® ST (G/72100/XXXX/EN 1019 Rev01) 31 / 80
12 Perform a Measurement
Perform a measurement for each eye before you save the data. To perform
a measurement, you must
 Start the Corvis® ST program at the computer, sec. 12.1, page 31
 Adjust the Corvis® ST, sec. 12.2, page 32
 Start the measurement, sec. 12.3, page 37
 Perform a second measurement,sec. 14.3, page 52
 Save the data, sec. 12.5, page 38
 Complete the measurement, sec. 12.6, page 39
You can use the patient data management, sec. 12.7, page 40
12.1 Start the Corvis® ST Program at the Computer
 Select a patient´s name.
 Press the [Corvis® ST] button to start the Corvis® ST program.
Condition: Autostart must be activated in the Corvis® ST software set-
tings. See User Guide.
Abb. 12-1: Start Corvis® ST program