11 Preparing a meas urement
Instruction Manual Corvis® ST (G/72100/XXXX/EN 1019 Rev01) 23 / 80
11 Preparing a measurement
In order to transfer data from the device to your computer/laptop you
have to install the following software on your computer:
the Corvis® ST program
the USB connection must be enabled in the „Settings 2: USB Trans-
fer“ of the Corvis® ST device.
the Patient Data Management software
For more information see the User Guide.
11.1 Using the control unit
You enter and manage patient data with the control panel. In addition,
you start the measurements and can view the results with it.
1 Display 4 Joystick button
2 Control knob 5 Screen-dependent Buttons
3 Joystick
Abb. 11-1: Functions of the control unit