OCULUS Corvis ST - Enter a New Patient

11 Preparing a measurement
28 / 80 Instruction Manual Corvis® ST (G/72100/XXXX/EN 1019 Rev01)
☞
Recommendation: Import the patient data with the option "Folder".
 Press the [...] button. (2)
 In the dialog box, select the directory or the file where the patient
data is located: .DAT and .BMP.
 Confirm your selection with [OK] or [Save].
The patients that are located and the associated examinations are
displayed in the lower part of the dialog.
 To import the data, press the [Import] button (4).
The data will then be available in the Patient Data Management
software.
11.4.1 Enter a new patient
☞
You can only start a measurement from the computer/laptop if you have
entered a patient in the patient data management.
If you start the measurement from the computer software, the patient
data are transmitted (via USB cable) to the Corvis® ST and are saved there.
After the measurement with the Corvis® ST has been completed, the ex-
amination data for the patient in question are automatically saved to the
computer/laptop.