OCULUS Corvis ST User Manual

14 Perform a measurement with the Corvis® ST unit
48 / 80 Instruction Manual Corvis® ST (G/72100/XXXX/EN 1019 Rev01)
14 Perform a measurement with the Corvis® ST unit
You can perform an examination with the Corvis® ST unit alone and can
directly save the patient and examination data there.
The procedure for this is as follows:
 Switch on the Corvis® ST, sec. 10.5.1, page 21.
 Enter the patient data, sec. 14.2, page 49
 Prepare and execute the measurement, sec. 14.2.2, page 51
 End the measurement, sec. 14.4, page 52
 Re-use the patient and examination data, sec. 14.5, page 53
Buttons and Icons
14.1 Change Settings
☞
You can change the default settings for your own individual measuring
mode. For detailed information, refer to the User Guide.
Button Function
This button appears after the measurement
to save examination data of the patient
Switching to the “Dynamic Corneal Response“
(DCR) screen
Switching between eyes/displays
Printing measurement results
 Press this button to start printing
Measurement is available, displaying the
measurement
 Press this button to display further
measurements
R or L
Display of the examined eye

OCULUS Corvis ST Specifications

General

Brand	OCULUS
Model	Corvis ST
Category	Medical Equipment
Language	English