OERTLI OS 4 - Page 35

2021-03-23 / Rev. 10 VV016042 35
9.7.1.2 Parameter misc
On this page, various parameters can be set. Any changes made must be saved by means of <Write Config>.
Equipment type:
Type that indicates how the software communicates with the laser module:
3500: module is used with service software (USB connector)
3100: default - module is controlled by OS 4 software
Power TLD:
Minimum power of the TLD, default is 3
Sound:
Minimum level of internal beeper, default is 3
UPF Passive Allowed:
Always set yes