OHAUS AP310 - Navigating Balance Menus

11
OPERATION
Each menu contains selections (submenus) which can be set for specific operations.
The
MODE
button is used to advance though the submenu selections. The
ON
TARE
button enters
or accepts the submenu selection and returns to the beginning of the submenu selection.
The
PRINT
button is used to backup in the submenu if a change is desired.
The following sample illustrates the USER menu and submenu items
Navigating the Menus
There are four menus used in the balance:
CALIBRATION USER SETUP PRINT
To enter the menus, the
ON
TARE
button is pressed and held until MENU is displayed. When
released, CAL is displayed which is the Calibration menu.
When in the menus, repeated pressing of
MODE
advances through the
menus. CALIBRATION USER SETUP PRINT END
MENU
RULES: Use
MODE
button to advance.
Use
ON
TARE
button to enter or accept submenu.
Use
PRINT
button to backup.
After selections are made, always exit menus through END
MENU
to
store settings.
NOTE:
Each menu is constructed
in the form of a loop.
Advancing from one
submenu item to the next
by using the
MODE
button
will eventually return to
the beginning of the menu
* Only on AP250D Models.
STABILTY
AL
RESET
USER
END USER
DUAL
AUTO ZERO
ON
OFF
ON
OFF
YES
NO
0
1
2
0
1
2
3
Menu
Menu