OHAUS AP310 - Time

47
MENUS
Fill Option (Cont.)
5.
MODE
. If REF WT is
selected, a sample reference weight is used later to set the weight parameter into the
balance. If NUMBER is selected, a number representing the desired sample weight
has to be entered. Select either REF WT or NUMBER.
6.
ON
TARE
.
7.
MODE
. When target is selected, the balance will show the
normal weight of the object on the pan.
8.
ON
TARE
.
9.
MODE
or . When zero is se-
lected, the balance indicates the weight as a negative number after the reference is set
in the main menu. When an object is placed on the balance that weighs exactly what
the reference was set to, the display shows zero with a full bar graph.
10.
ON
TARE
.
11.
MODE
.
12.
ON
TARE
.
13.
MODE
.
14.
ON
TARE
.
Time
Time is a feature which enables the balance to be set to the current time in either U.S.A.
standards (12 hour periods) or European/Military standards (24 hour periods). The default
setting is US Standard. To enter time, proceed as follows:
1. Access the
submenu which is under the Setup menu.
2.
ON
TARE
.
3.
ON
TARE
.
4.
MODE
or .
5.
ON
TARE
.
SETUP
Ref _ıT NU^]BeR
Ref
TaR9eT
TO Ref TO 2eR0
TaR9eT
eND
f IllopT
eND
opT ION5
T I^]e
Type
us
us euRo
Type
Menu
Menu