OHAUS AP310 - Type Approved;Lft; Unit Selection

37
MENUS
Type Approved/LFT
LFT can be set to ON or OFF. Selecting ON automatically sets the parameters shown in the
table to conform to type approved requirements. For sealing method, refer to Type Approved
Sealing section. Default setting are shown as follows:
Lockswitch Menu Setup Locked
Print Stable Data Only ON
Weighing Units
g Grams
dwt Pennyweight
ct Carats
oz Ounces
ozt Troy ounces
UNIT1 Grains
t Taels (see note)
UNIT2 Mommes
UNIT3 Custom
1. Access the submenu.
2.
ON
TARE
.
3.
MODE
or .
4.
ON
TARE
.
Unit Selection
The Unit Selection (SEL) submenu permits
the selection of weighing units for use dur-
ing operation. The balance can display
weights in every unit of measure listed in
table. The default setting is shown in bold
type.
NOTE:
If Taels is enabled, see next page before
exiting the menu.
To view or change the various weighing units:
1. Access the
submenu.
2.
ON
TARE
.
3.
MODE
or .
4.
ON
TARE
for next unit status.
5. Repeat steps 2 through 4 for each unit.
6.
ON
TARE
.
g
gg
lfT
oN
oN off
lfT
sel
oN"
oN" off"
sel
Menu
Menu