OHAUS AP310 - Print Numeric Data Only; Print Stable Data Only

57
MENUS
Initialize (Cont.)
11. After the last digit is entered,
is displayed again.
12.
MODE
for the high limit.
13.
ON
TARE
indicates current high end value.
14. Repeat steps 8 through 10 to change the numbers as required.
15. After the last digit is entered,
displayed again.
16.
MODE
.
17.
ON
TARE
.
Print Stable Data Only
When enabled, this feature permits only stable display data to be output. To set the feature
ON or OFF, proceed as follows:
1. Access the
submenu under the Print Options menu.
2.
ON
TARE
.
3.
MODE
or .
4.
ON
TARE
.
Print Numeric Data Only
This submenu is used to select numeric data only, or full display data for RS232 output. Set
this feature ON to output numeric display data only, or OFF to output full display data as
follows:
1. Access the
submenu under the Print Options menu.
2.
ON
TARE
.
3.
MODE
or .
4.
ON
TARE
.
NON-pl
NON-ph
0000000
NON-ph
eND
iN IT
sTaBle
off
off oN
sTaBle
NU
off
off oN
NU
Menu
Menu