OHAUS AP310 - Averaging Level; Stability Range

33
MENUS
Averaging Level
Averaging level compensates for vibration or excessive air currents. Factory default setting
is shown in bold type.
AL 0 reduced stability, fastest stabilization time
AL 1 normal stability, normal stabilization time
AL 2 more stability, slow stabilization time
NOTE: Averaging level does not affect balance accuracy, but it does affect stabilization
To view or change the averaging level:
1. Access the Averaging Level
submenu.
2.
ON
TARE
.
3.
MODE
to select through .
4.
ON
TARE
.
Stability Range
The stability range specifies the weighing results must be within a preset tolerance limit for
a certain time to turn the stability indicator ON. When a displayed weight changes beyond
the allowable range, the stability indicator turns OFF, indicating an unstable condition.
Factory default setting is shown in bold type.
Stb 0 Smallest range: stability indicator is ON only when displayed
weight is within a preset tolerance limit for one second.
Stb 1 Normal range.
Stb 2 Larger range.
Stb 3 Largest range: stability indicator is ON when displayed
weight is within a preset tolerance limit for several seconds.
When the RS232 interface is configured to print stable data only, the stability range also
governs data output. Displayed data will only be output if it is within the selected stability
range.
To view or change the stability range:
1. Access the Stability Range
submenu.
2.
ON
TARE
.
3.
MODE
to select through .
4.
ON
TARE
.
al
al 1
al 0 al 2
al
sTB
sTB 1
sTB 0 sTB 3
sTB
Menu
Menu