Oki MICROLINE MX Series - Configuring the Emulation with the Control Panel

Chapter 4 IGP/PGL Emulation
126
Configuring The Emulation With
The Control Panel
You can select PGL default parameters directly from the control
panel or by control codes as explained in the
IGP/PGL
Programmer's Reference Manual.
The PGL parameters are
described on the following pages. Parameters marked with an
asterisk (*) indicate the default value. The printer must be offline to
enter the configuration structure.
Pressing an invalid key to enter a parameter value may move you
to another level in the configuration or exit the configuration menu
completely. Configure the IGP/PGL according to your specific
requirements.
IMPORTANT BEFORE you reconfigure the IGP/PGL, print a configuration
sheet to see all of the current settings.