Epson FX Emulation
265
PTX Linefeed
• Disable (disable). The default. Linefeed is to be performed as
calculated from the bottom of the graphics or barcode, thereby
disrupting the vertical text alignment.
• Enable. The Linefeed moves to the next line as calculated from
the Top of Form position, thereby retaining vertical text
alignment. When printing graphics or bar codes, you may want
to set the PTX Linefeed parameter to Enable to maintain text
alignment.
LPI Adjust
This parameter lets you specify the lines per inch (lpi) values: 6 LPI
(the default) or 8 LPI.
Page L./Lines
This parameter lets you set physical page length in lines from 12 to
96 at 6 lpi, or 16 to 128 at 8 cpi. The default is 66 lines at 6 lpi.
NOTE: If 6 lpi is selected, you will be able to scroll the menu to 128
(an invalid length). However, when you press ENTER to
select this value, the menu will return with the maximum
lines for 6 lpi (i.e., 96 lines). Similarly, selecting too few
lines for 8 lpi will cause the menu to return with 16 lines.
Linefeed
LINE 1
Linefeed
LINE 2
LINE 3
LINE 1
LINE 2
LINE 3
PTX Linefeed Enabled PTX Linefeed Disabled
PCL-II Emulation
To Next Page
Loading...
