Chapter 4 Coax/Twinax (CTHI) Emulation
180
Prt Partial Line
• Enable (default). Forces the printer to print a partial line (i.e.,
line not ending with a LF) before moving to the top of form on
the next page.
• Disable. The last partial line of data will not be printed.
Device ID
This parameter defines the printer emulation as 4234-2 or 5225.
After the emulation has been changed, a POR status is sent to the
host. 4234-2 is the default.
Device Address
Allows you to set the device address from 0 through 6. The host
directs data and commands on the twinax line to a specific device
based on its unique device address. After the address has been
changed, a POR status is sent to the host.
5225 World Trade
The 5225 emulation has a standard multinational character set that
serves as a base and 14 extended world trade character set
assortments.
Cancel IGP/DCU
• Enable (default). Cancels all buffers when a job is put on hold
from the host or the CANCEL key is pressed.
• Disable. Does not cancel any internal buffer in the printer when
a job is put on hold from the host or the CANCEL key is
pressed.
To Next Page
Loading...
