Epson FX Emulation
283
File System
• Overwrite Files. Allows you to prevent files from being
overwritten by disabling the overwrite function.
• View File List. Displays the list of files in the file system.
Pressing the DOWN key displays the file size.
• Delete Files. Displays the list of files in the file system.
Pressing the ENTER key deletes the file displayed on the front
panel.
Flash Avail. The amount of flash available for the user to save or
download files into flash.
• Optimize&Reboot. Reclaims flash space from deleted flash
files. After pressing ENTER, wait for the printer to reboot.
NOTE: When the Optimize&Reboot option is executed, the
message, “Optimizing Flash Files” does not display before
printer rebooting takes place.
• Print File List. Prints a summary of the files stored in flash
memory and several statistics on File System usage.
IMPORTANT
Do not turn the printer off until it has completely rebooted and
is either back online or offline.
Set Sharing
This option allows character sets to be shared between the active
LP+ protocol and the active IGP emulation. If CT is installed and
active, choosing a character set in the CT activates that character
set in the active IGP and LP+ protocols. (These changes will not be
visible on the front panel.) If Set Sharing is not selected, only the
LP+ will share the CT's character set.
Switching host interfaces from CT to Centronics when the Set
Sharing is enabled will cause the LP+ character set to be activated
to the same character set of the active IGP, if possible.
ADVANCED USER
To Next Page
Loading...
