Chapter 3 Integrated Print Management System
50
9. Turn the left spool by hand to make sure the ribbon tracks
correctly in the ribbon path and around the ribbon guides.
10. Close the platen lever.
11. Close the printer top cover.
If you want to increase the darkness level of the ribbon at the end of
life, go to “Ribbon End Point” on page 275 and follow the
procedures for adjusting the image density.
If you are satisfied with the print darkness, press the
ON LINE/CLEAR key twice to return the printer to operation.
Cancel A Print Job
The procedure to cancel a print job depends on the printer
emulation and your application software. Contact your system
administrator for additional information.
1. If the printer is online, press ON LINE/CLEAR to place the
printer in offline mode.
2. From the host system, stop the print job.
NOTE: If the print job is not stopped from the host system before
pressing CANCEL, the print job continues with data
missing when the printer returns to online mode. Exercise
caution to prevent unwanted data loss occurrences, as this
function deletes unprinted data in the printer. This function
is active only in offline mode; the purpose of this function is
to eliminate the necessity of printing unwanted data when
print jobs are canceled.
3. Press CANCEL.
NOTE: You may need to enable the Cancel option on the front
panel. See “ADVANCED USER” on page 279 for details.
4. Set the top-of-form. Refer to the Quick Setup Guide.
To Next Page
Loading...
