Optimizing Print Speed
77
Form Length
Form length is the number of lines that can be printed on a page.
You can set the form length in inches, millimeters (mm), or as a
function of the current lpi (lines per inch).
Form Width
The form width can be specified in inches, millimeters, or as a
function of the current cpi (characters per inch). The forms width set
should not exceed the actual paper width.
Vert Forms
• Bot Frm 66/6 (default). This option sets the bottom margin for
the forms. You must specify the bottom margin in lines (at 6
lines per inch), ranging from 0 to 198 lines (33 inches). The
default setting is 66. Press the right arrow to increase the value,
left arrow to decrease the value, and ENTER to change units.
Selecting a value for this option resets the top margin to 0, so
the top margin must be redefined after this option is selected.
• Top Mrg 6/0 This option sets the top margin for the forms. You
must specify the top margin in lines (at 6 lines per inch),
ranging from 0 to 198 lines (33 inches). The default setting is 0.
Press the right arrow to increase the value, left arrow to
decrease the value, and ENTER to change units. The margins
will automatically adjust so that the top and bottom margins do
not cross each other.
QUICK SETUP
To Next Page
Loading...
