Changing Ribbons
47
Changing Ribbons
Before changing the ribbon, determine whether you want to make
the print lighter (extend the ribbon life) or darker (shorten the ribbon
life). If you want to make the print lighter, go to “Ribbon End Point”
on page 275 and follow the procedures for adjusting the image
density. If you are satisfied with the print darkness, or if you want to
increase the darkness at the end of ribbon life, continue with the
following steps.
Figure 19. Preparing to Load the Ribbon
1. Open the printer cover.
2. Raise the platen lever as far as it will go.
3. Close the tractor doors.
4. Remove the old ribbon and discard properly.
Blue Tractor
Door (2)
Platen Lever
To Next Page
Loading...
