IGP/VGL Submenu (with LG)
159
Error Handling
Following are several options which define how errors are reported.
Error Msgs
• Enable (default). Command syntax is checked and error
messages printed when command parameters are incorrect.
• Disable. Error checking and error messages are suppressed.
Error Markers
• Enable (default). Prints the following error markers for those
elements that print beyond the page boundaries:
>> for elements that begin off the right side of the page;
<< for elements that begin at the indicated position but end off
the page;
♦ for elements where the starting position of the
command contains an error other than an off-page error.
Offpage Errors
• Disable (default). Does not report errors for elements that start
or end beyond the right edge of the page.
• Enable. Reports errors for elements that start or end beyond
the right edge of the page.
Barcode Errors
• Enable (default). An error message will print when invalid
barcode data is encountered.
• Disable. VGL will not print an error for illegal barcode data; the
barcode will be skipped.
NOTE: When the Barcode Errors option is disabled, the VGL
emulation will try to make the best use of invalid data by
either truncating extra digits or adding zeros to the end of
barcode data to meet minimum data length requirements
for some barcodes. Not all errors will be corrected.
IGP/VGL Submenu
To Next Page
Loading...
Need help?
General