Oki MICROLINE MX Series - Centronics (Parallel) Submenu

Centronics (Parallel) Submenu
89
Centronics (Parallel) Submenu
Data Bit 8
• Enable (default). Allows access to the extended ASCII
character set.
• Disable. The printer interprets bit 8 of each incoming data
character as a zero, regardless of its actual setting.
Centronics
(from page 83)
Data Bit 8
Prime
Signal
TOF Action
Buffer Size
in K
Enable*
Disable
Enable*
Disable
Standard*
Inverted
Standard*
Inverted
Enable*
Disable
Leading*
Trailing
Enable*
Disable
Reset*
Do Nothing
16*
(1-16)
* = Factory Default
PI Ignored Data
Polarity
Resp.
Polarity
Busy on
Strobe
Latch Data
On
Auto
Trickle
Disable*
Enable
Trickle
Time
1/4 sec*
1/2 sec
1 sec
2 sec
4 sec
8 sec
16 sec
Off