IGP/PGL Submenu (with LG)
131
Define CR (Carriage Return) Code
This parameter forces the printer to insert an automatic Line Feed
code into the data stream whenever a Carriage Return code
occurs. This is to be used only if the host computer does not send
line feeds to the printer.
• CR = CR (default). Does not perform a line feed. The next print
position will be print position 1 of the current line.
• CR = CR + LF. Performs an automatic line feed. The next print
position will be print position 1 of the next line.
Define LF (Line Feed) Code
This parameter forces the printer to insert an automatic Carriage
Return code into the data stream whenever a Line Feed code
occurs. This can be used in most installations, but it is required if
the host computer does not send carriage returns to the printer.
• LF = LF (default). Does not perform an automatic carriage
return. The next print position will be the current print position of
the next line.
• LF = CR + LF. Performs an automatic carriage return. The next
print position will be print position 1 of the next line.
Autowrap
This parameter determines if text will wrap to the next line when the
line of text exceeds the right margin.
• Disable (default). Truncates the text beyond the right margin
until a CR or CR + LF is received.
• Enable. Automatically inserts a CR + LF after a full print line.
PGL SFCC
You can specify which hex code (1-255) will be used as the Special
Function Control Code (SFCC). The factory default setting is 126.
The SFCC denotes that the following data is a PGL command.
IGP/PGL Submenu
To Next Page
Loading...
