Chapter 4 IGP/VGL Emulation
154
True Vert 1/10
• Enable (default). A vertical 1/10 inch parameter is used as 1/10
inch. Rounding occurs to the nearest 1/72 inch. This can cause
vertical moves that have the same value to differ by
± 1/72
inch.
• Disable. A vertical 1/10 of an inch parameter is used as 7/72 of
an inch. The absolute move is slightly smaller than expected.
For example, a one-inch move would be 70/72 of an inch.
Vertical moves that have the same value are identical in length.
Absorb After ^PY
• Absorb Motion (default). The first paper motion following a
^PY command is ignored.
• Absorb All. The system ignores all the data and terminator
until a host generated motion terminator is detected.
• Disable. System terminators following a graphics command
are sent to the printer and result in paper motion.
UPC Descenders
• Enable (default). UPC/EAN barcodes are printed with
descenders, even if there is no human readable data.
• Disable. UPC/EAN barcodes are printed without descenders if
there is no human readable data.
Rot. Char Size
• Adjusted (default). Rotated (clockwise/counterclockwise),
expanded characters have a different size than an unrotated
character with the same size parameters.
• Not Adjusted. Rotated, expanded characters are the same
size as unrotated characters with the same size parameters.
To Next Page
Loading...
