Chapter 4 LinePrinter Plus Emulation (with PCL-II)
232
Printer Select
• Disable (default). Ignores the ASCII DC1 and DC3 control
codes.
• Enable. Disables the printer when a DC1 control code is
received, and enables the printer when a DC3 control code is
received.
Alt. Set 80-9F
• Control Code (default). Interprets data in the range of hex 80
through hex 9F as a control code.
• Printable. Prints data in the range of hex 80 through hex 9F.
Character Set
Specifies a character set as shown in the “Serial Matrix Character
Set Menu” on page 233. To use one of these sets, choose the
desired group heading (such as European Sets) and press ENTER.
Then choose the desired set within that group (such as Roman 8)
and press ENTER. Both the group and the desired set will be
starred to indicate your selection. Character sets are shown in
detail in the
Character Sets Reference Manual
.
ESC d command
• Even dot plot (default). Interprets the ESC d command as
even dot plot.
• Double high. Interprets the ESC d Command as double high.
Select this option for backward compatibility.
To Next Page
Loading...
Need help?
General