Proprinter XL Emulation
235
Auto LF
This option defines the printer action when print data is received
past the forms width setting.
• Enable (default). Performs an automatic carriage return and
line feed when data is received past the forms width.
• Disable. Discards any data past the forms width.
Define LF Code
• LF = LF (default). Does not perform an automatic carriage
return when a Line Feed command is received. The next print
position will be the current print position of the next line.
• LF = CR + LF. Forces an automatic carriage return with each
Line Feed command received. The next print position is print
position 1 of the next line.
FF Valid at TOF
• Enable (default). Performs a form feed when the host sends a
Form Feed command and the printer is at the top of form.
• Disable. Will not perform a form feed when the host sends a
Form Feed command and the printer is at the top of form.
Character Set
Specifies a character set as shown in the “Proprinter XL Character
Set Menu” on page 237. To use one of these sets, choose the
desired group heading (such as European Sets) and press ENTER.
Then choose the desired set within that group (such as Roman 8)
and press ENTER. Both the group and the desired set will be
starred to indicate your selection. Character sets are shown in
detail in the
Character Sets Reference Manual
.
To Next Page
Loading...
Need help?
General