Epson FX Emulation
249
Slashed Zero
This parameter allows you to print the numeral “0” with or without
the slash. This option applies to all character sets except OCR-A
and OCR-B.
• Disable. Zero is printed without a slash.
• Enable. Zero is printed with a slash.
Page Format
Margins
• Left Margin. Defines where the first print column is located.
The left margin is specified as the number of characters from
the left edge of the form.
• Right Margin. Defines where the last print column is located.
The right margin is specified as the number of characters from
the right edge of the form.
• Top Margin. Defines the location of the first print line on the
page. The top margin is specified as the number of lines from
the top of the form's position.
• Bottom Margin. Defines the location of the last print line on the
page. The bottom margin is specified as the number of lines
from the bottom of the form's position.
Form Length
Specifies the form length in lines. The maximum form length in lines
depends on the current LPI setting; it is equal to the maximum form
length in inches multiplied by the current LPI setting. For example,
at 6 LPI the maximum form length is 6 LPI x 24 inches = 144 lines.
Only valid form length values will be accepted. If you select a length
that is larger than the maximum length for the current LPI, the
maximum length will be used. If you need a longer page length, you
must first change the LPI.
ANSI Emulation
To Next Page
Loading...
Need help?
General