Oki MICROLINE MX Series User Manual

Fault Messages
327
ERROR: SHORT AT
ADDRESS XXXX
No Hardware failure in
SDRAM or
controller circuitry.
Contact your authorized
service representative.
1
ERROR: WRITING
TO FLASH
No Hardware or
software fault in
flash memory.
Contact your authorized
service representative.
1
ERROR: WRONG
CHECKSUM
No The printer
received the
complete program
but the checksum
did not match.
Contact your authorized
service representative.
1
ERROR: WRONG
OEM OR PRINTER
TYPE
No The SPX inserted
in the debug port is
not intended for
this model printer
or this OEM.
Contact your authorized
service representative.
1
ETHERNET
ADAPTER BEING
INITIALIZED
N/A Status message
indicating that the
Network Interface
Card is processing
the boot
procedure.
No action is required.
ETHERNET
DETECTED
N/A Status message
indicating that the
Network Interface
Card has
established
connection.
No action is required.
EXCESS RBN
WEAR
Install New RBN
Yes Displayed when
ribbon reaches end
of life
Install a new ribbon.
Table 15. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution

Oki MICROLINE MX Series Specifications

General

Brand	Oki
Model	MICROLINE MX Series
Category	Printer
Language	English