Reload Paper
33
1. Raise the printer cover. Raise the platen lever as far as it will
go. (See Figure 4 on page 24 for the location of the lever.)
2. Press ON LINE/CLEAR to turn off the alarm. Do not open the
tractor doors or remove the existing paper.
3. For cabinet models, open the front door. Align the paper supply
with the label on the floor. Ensure the paper pulls freely from
the box.
4. Feed the paper up through the paper slot (see Figure 6). It may
be easier to feed one corner of the new paper up through the
slot first. When this corner can be grasped from the top, rotate
the paper back to the normal position.
NOTE: If you are using thick, multi-part forms and are unable to
load the new paper over the existing paper, go to step 16.
5. Hold the paper to prevent it from slipping down and through the
paper slot.
To Next Page
Loading...
