Oki MICROLINE MX Series - Page 334

Chapter 7 Diagnosing Problems
334
PAP NOT SCHED* No Fatal firmware
error on controller
board.
Contact your authorized
service representative.
1
PAP NT AT SPEED* No Fatal firmware
error on controller
board.
Contact your authorized
service representative.
1
PAP UNEXP INT* No Fatal firmware
error on controller
board.
Contact your authorized
service representative.
1
PARAMETER
ERROR*
No Illegal parameter
value received in
command code.
Contact your system
administrator.
PARITY ERROR Yes Parity error
(serial interface)
Check your printer serial
interface parameter
settings; if necessary,
adjust them so that they
match the settings of the
attached host.
PLAT INV CMD* No Fatal firmware
error on controller
board. Platen
Invalid Command.
Contact your authorized
service representative.
1
PLAT INV PARM* No Fatal firmware
error on controller
board. Platen
Invalid Parameter.
Contact your authorized
service representative.
1
PLAT INV STATE* No Fatal firmware
error on controller
board. Platen
Invalid State.
Contact your authorized
service representative.
1
Table 15. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution