Oki MICROLINE MX Series User Manual

Chapter 7 Diagnosing Problems
340
STACKER FAULT Yes Stacker is not
functioning
correctly.
Check for obstructions in
the stacker area. If fault
persists, contact your
authorized service
representative.
1
STACKER FULL Yes Power stacker is
full of paper.
Remove paper.
STACKER JAM Yes This message is
triggered if there is
paper inside the
throat of the
stacker elevator,
but the elevator is
not moving.
1. Open the cabinet rear
door and check for
obstructions preventing
elevator movement.
Remove any
obstructions.
2. Run the print job again.
If the message appears
again, contact your
authorized service
representative.
1
TABLE MISMATCH
DOWNLOAD AGAIN
No Indicates that the
software update
has failed and
should be
reloaded.
Contact your authorized
service representative.
1
TCB CORRUPTED* No Fatal firmware
error on controller
board.
Contact your authorized
service representative.
1
TCP PORT BUSY Yes Error message
reported by the
Printer Manager
when ethernet
interface option is
installed.
Refer to the printer’s
Maintenance Manual .
Table 15. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution

Oki MICROLINE MX Series Specifications

General

Brand	Oki
Model	MICROLINE MX Series
Category	Printer
Language	English