EQ / EFX
7.6
Saving EQ and EFX in the song
Using OkyWeb2, Presets can be edited but not overwritten or saved as new Presets.
N.B.: Remember that you can always prepare your own Presets and add them to the Preset library saved on the Compact Flash card, by
means of the PC software provided.
Presets and any changes made to them can however be saved directly in the individual songs, in order that each
backing track can have its own specific effect (Preset + changes).
This procedure is carried out processor by processor, thus enabling to choose which effect and which equalizer
of those being used is saved in the backing track.
Saving processor settings in a selected song
Press the EQ/EFX key repeatedly to select the required processor.
For MIC processors, it’s sufficient to select the processor’s page (no matter what the parameter);
for MUSIC EFX processors on the other hand, also select the processor required using the UP and DOWN keys
For example: if you want to save the equalization of the backing track, point the cursor on EQ/3D.
Use the key combination SHIFT (LED lit) + ENTER/SAVE.
All the processor’s settings are saved in the song on the Compact Flash card: every time the song is performed
from then on, it will reproduce the settings as they have been saved.
N.B.: the data are saved in the initialisation of the song, i.e., saved as static data, located before the musical performance.
Saving procedure is particularly suited to backing tracks without tracks specifically conceived for controlling the processors: in fact, any
dynamic changes already contained in the song (such as a change of effect or equalizer in the various phases of the song) are not changed.
Removing EQ and EFX from the song
If you wish to remove the EQ / EFX settings you have saved in the song:
carry out exactly the same procedure as for saving, but simply choose the Preset =======
E.g.: to cancel the settings of the equalization used for your voice, select
the MIC EQ processor, then the MIC EQ PRESET parameter, choose the
Preset = = = = = =
Then, lastly, use the key combination Shift (LED lit) + ENTER/SAVE.
N.B.: this procedure only eliminates the processor’s instructions in the
initialisation of the song, leaving any dynamic changes contained in it
unaltered.
To exit the EQ/EFX environment
Press EXIT to exit the EQ/EFX environment.
N.B.: returning to the EQ/EFX environment, the cursor goes directly to the last control edited
MIC ECHO
→EchoPRESET: ======
EchoTIME:=== FEEDBACK:===
SYNCtoMIDI: ===
EchoSEND:074
SELECT ECHO PRESET
To Next Page
Loading...