159
10
Transferring images to a computer
Connecting the camera to a computer
Connect the camera to your computer with the provided USB cable.
1 Insert the marked end of the
provided USB cable into the USB
port on your computer.
• The location of the USB port varies
depending on the computer. For details,
refer to your computer's manual.
2 Insert the provided USB cable into
the multi-connector.
3 Set the camera's power switch to
ON.
• The selection screen for the USB
connection is displayed.
4 Use ac to select [STORAGE].
Press the i button.
Look for this mark.
USB port
Terminal
USB cable
Multi-connector
Smaller
terminal
Power switch
s0004_e_Advanced.book Page 159 Tuesday, September 27, 2005 4:15 PM
To Next Page
Loading...
