Olympus OmniScan MX - Probe Connectors; Figure L-1 the ECT Module with the 1 CH and 4 CH Connectors; Figure L-2 the 4 CH, 19-Pin Eddy Current Probe Connector; L.3 Probe Connectors

DMTA-20015-01EN [U8778402], Rev. M, February 2017
Appendix L 174
Figure L-1 The ECT module with the 1CH and 4CH connectors
L.3 Probe Connectors
The probes can be connected to the eddy current module using two types of
connectors.
• The first type is a 19-pin connector (see Figure L-2 on page 174) used in
multiple-coil eddy current technology probes.
Figure L-2 The 4CH, 19-pin eddy current probe connector
The references for this connector are found in “4CH Connector References” on
page 175.
• The second type is a BNC connector (see Figure L-3 on page 175) used in certain
single-coil eddy current technology probes.