DMTA-20015-01EN [U8778402], Rev. M, February 2017
Basic Operation
37
You can also turn off the OmniScan MX2 by pressing and holding the Power key for
ten seconds. However, your setup will NOT be saved.
2.2 Automatic Start-Up Mode
The OmniScan MX2 has an automatic start-up mode: auto-boot. Use the auto-boot
mode to remotely start the OmniScan MX2 instrument. When this mode is enabled,
you do not need to press the Power key ( ) to start the OmniScan MX2. The
OmniScan MX2 starts up automatically when connected to a DC power adaptor. This
mode is disabled by default.
To activate the auto-boot
1. Turn off the OmniScan MX2 instrument, remove the batteries, and then
disconnect the DC power adaptor.
2. Press and hold the Power key ( ).
3. Connect the OmniScan MX2 to a DC power adaptor.
4. Wait for the power indicator light to blink two times, and then release the Power
key ( ).
5. To deactivate the auto-boot, repeat steps 1 to 4.
2.3 Power Supply Management
The OmniScan MX2 is a portable instrument that can draw power from either
lithium-ion batteries or a DC power adaptor.
To Next Page
Loading...
