DMTA-20015-01EN [U8778402], Rev. M, February 2017
List of Figures
201
List of Figures
Figure i-1 The OmniScan MX2 ............................................................................................. 1
Figure i-2 The OmniScan MX ............................................................................................... 2
Figure i-3 Module identification label ................................................................................ 2
Figure i-4 The OmniScan MX2 membrane vent ................................................................ 7
Figure 1-1 Front panel of the OmniScan MX2 .................................................................. 26
Figure 1-2 Right side panel of the OmniScan MX2 ......................................................... 30
Figure 1-3 Left side panel of the OmniScan MX2 ............................................................ 31
Figure 1-4 Top panel of the OmniScan MX2 ..................................................................... 32
Figure 2-1 The Shut Down button ...................................................................................... 36
Figure 2-2 Saving the setup ................................................................................................. 36
Figure 2-3 The OmniScan MX2 DC power adaptor plug ............................................... 38
Figure 2-4 Battery charge status: Charge remaining in both batteries ......................... 40
Figure 2-5 Removing a lithium-ion battery ...................................................................... 42
Figure 2-6 Attaching a ferrite clamp filter to a cable (example shown with the
scanner interface cable) ..................................................................................... 47
Figure 2-7 OmniScan MX2 connection diagram — ferrite clamp filters ...................... 48
Figure 3-1 Module with PA connector cap ....................................................................... 53
Figure 6-1 The serial connector .......................................................................................... 66
Figure 6-2 The scanner interface LEMO connector (contact view) ............................... 67
Figure 6-3 The alarm and I/O connector ........................................................................... 70
Figure 7-1 Front panel of the OmniScan MX .................................................................... 78
Figure 7-2 Information provided on each key ................................................................. 80
Figure 7-3 Right side panel of the OmniScan MX ........................................................... 85
Figure 7-4 Left side panel of the OmniScan MX .............................................................. 86
Figure 7-5 Top panel of the OmniScan MX ....................................................................... 87
Figure 8-1 The OmniScan MX DC power adaptor plug ................................................. 91
Figure 8-2 Battery charge status: Charge remaining in both batteries ......................... 92
Figure 8-3 Removing the lithium-ion battery ................................................................... 94
Figure 8-4 Attaching a ferrite clamp filter to a cable (example shown with the
4CH/MUX cable) ................................................................................................ 99
To Next Page
Loading...
