3-48
Bank/Func-
tion
POSITION/OFFSPEED/ONSetting
range
Function nameCam/Parame-
ter
P (p)
(see note 4)
--- Pulse output
setting
--- Writes pulse output
program to any
bank or cam
number (sets pulse
number).
(Sets pulse start
position.)
t (t)
(see note 4)
0 Data transfer
(Slave setting)
--- (Operates on a
command issued
from Master Unit)
---
1 Data transfer
(Master setting)
0 to 3 0: Disabled (factory
setting)
1: Read data
2: Write data
3: Verify data
---
U (u)
1 Function level
selection
0 to 2 0: Function level 0
(monitor only)
1: Function level 1
(basic
operation/monitor
only) (factory
setting)
2: Function level 2
(all functions)
---
Note 1. The data for the 3F88L-160 (16-point model) Cam Positioner is shown in parentheses.
Note 2. The data for 720 resolution (divisions/revolution) is shown in parentheses. The angles will be
set and displayed as “1” for 0.5°.
Note 3. Functions A, b, C, F, H, and U will be enabled after the power has been turned OFF and then
ON again.
Note 4. Functions P and t are special operations that are not stored as parameters.
Operation Chapter 3
To Next Page
Loading...
