3-59
H Origin Shift Execution (RUN Mode)
D Procedure
Operation Display Explanation
Use the mode selection switch to change to RUN mode.
(Manual
operation of
the
machinery)
Rotate the machinery to the position to be set as zero (or to the origin
compensation value).
Origin shift
input (TRIG)
Turn ON the origin shift input (TRIG) to execute origin shift.
The absolute angle (Resolver’s electrical angle) will flash in the
POSITION/OFF display until origin shift has been completed.
Turn ON origin shift
input (TRIG)
24 V DC
(After origin
shift has been
completed)
The original display will appear when origin shift has been completed.
The speed display will be “0” and present angle will be “0” if the
machinery is not operating.
Operation Chapter 3
To Next Page
Loading...
