0Function level 1 2
3-58
D Origin Compensation Absolute Angle (Display)
Function
No.
1 to 8 (1 to 4)
(see note)
Parameter
No.
0 Setting range (Display only)
• Use this parameter to display the origin compensation absolute angle (origin position after origin com-
pensation or origin shift for the Resolver’s electrical 0°) in the SPEED/ON display.
• If the parameter number is “0,” the same numeric value will be displayed, regardless of the function
number (1 to 8 or 1 to 4).
Note The numeric values for 720 (divisions/rotation) resolution are shown in parentheses.
Operation
Origin compensation
absolute angle (display)
Origin compensation
absolute angle (display)
Origin compensation
absolute angle (display)
Use the mode selection switch to change to SET mode.
H Origin Compensation Execution (SET Mode)
D Procedure
Operation Display Explanation
Use the mode selection switch to change to SET mode.
(Manual operation
of the machinery)
Rotate the machinery to the position to be set to zero.
Press the ADJ switch. Origin compensation will be executed.
The absolute angle (electrical angle of the Resolver) will be
flashing in the POSITION/OFF display until origin
compensation has been completed.
(After origin
compensation has
been completed)
The original display will appear when origin compensation has
been completed.
Note If the bank number appears in the Bank/Function display
and “0” appears in the Cam/Parameter No. display, the
absolute angle for origin compensation will be displayed
in the SPEED/ON display.
Use the mode selection switch to change to RUN mode.
The speed display will be “0” and present angle will be “0” if the
machinery is not operating.
Operation Chapter 3
To Next Page
Loading...
