Function level 2
3-70
H Related Parameters (SET Mode)
D Cam Protect
Function
No.
C (c)
Parameter
No.
--- Setting range ---
• Use this parameter to set or release cam protection for individual banks and cams.
• The factory setting is “no cam protection for any cam.”
Note This parameter is enabled when the power is turned OFF and then turned ON again.
Cam Protect Display
w SPEED/ON w POSITION/OFF
• The cam protect status for a particular cam number is shown by the ON/OFF status of the a 7-segment
indicator.
ON: Cam protected
OFF: Not cam protected
Note The 3F88L-160 (16-point model) Cam Positioner does not have cam numbers 17 to 32. (Those
indicators will remain OFF).
Operation Chapter 3
To Next Page
Loading...
