3-71
Operation
Outline for Setting and Releasing Cam Protect
Change modeSet function number CSet bank numberSet or release cam protectExit
Cam protect
Change to SET mode (using the mode selection switch)
Set the cam protect function number
Press the Set Key (enabling bank number selection)
Set the bank number to which cam protect is to be set or
cleared.
Press the Set Key (enabling cam protect settings).
Set or release cam protect.
Confirm settings
Press the Clear Key (enables bank number selection).
Press the Bank/Function Key (enables function number
settings).
If setting or clearing
cam protect for other
bank numbers.
Use the Bank/Function Key to set function number C.
The Bank/Function display will start flashing.
”C” will appear in the leftmost Bank/Function digit.
Use the Up and Down Keys to set the bank number.
The Bank/Function numeral will increase or decrease
as these keys are pressed.
The cam number will appear in the Cam/Parameter No.
display.
There are two ways to set or release cam protect.
• Setting/releasing by bank
Up + ON/OFF Switching Keys: Sets cam protect for all
cams in the bank.
Down + ON/OFF Switching Keys: Releases cam pro-
tect from all cams in the bank.
• Setting/releasing by cam
Use the Cam/Parameter Key to set the cam number,
and then press one of the following.
Up Key: Sets cam protect for the specified cam.
Down Key: Releases cam protect for the specified cam.
Once cam protect has been set/cleared for one bank,
press the Set Key and save the setting. “C” will flash
twice to confirm the settings have been saved.
The cam protect settings can be adjusted again if
required.
The Bank/Function display will flash.
The Cam/Parameter No. display will turn OFF.
The operation to set or release cam protect has now
been completed.
Operation Chapter 3
To Next Page
Loading...
