3-74
w Setting/Releasing Cam Protect by Cam
Cam protect (bank number 1)
Bank selection enabled status
(Bank/Function display flashing)
Cam protect settings enabled status
(current setting status displayed)
Cam protect (bank number 1, cam number 1)
Set
Release
Cam protect (bank number 1, cam number 2)
Set
Release
Cam protect (bank number 1, cam number 3)
Set
Release
Confirm settings
“C” flashes twice
(This example shows cam protect set for cam numbers 1 to 9.)
S While the bank and cam numbers are being displayed (cam protect settings enabled status), press
the Cam/Parameter Key and set the cam number for which cam protect is to be set or released.
S Press the Up Key to set cam protect for that bank and cam number. (The relevant indicators will
turn ON.) Press the Down Key to release cam protect for that bank and cam number. (The relevant
indicators will turn OFF.)
S To set or release cam protect for another cam number, press the Cam/Parameter Key, change the
cam number, and repeat the above operation.
S Once cam protect has been set or released, press the Set Key to confirm the setting. “C” will flash
twice. (Perform this operation for each bank. The setting will be canceled if the Set Key is not
pressed before moving to another bank.)
S Once the settings have been completed, press the Clear Key to return to bank selection enabled
status (Bank/Function display flashing).
S To set or release cam protect for another bank number (the above operation), use the Up and
Down Keys when in bank selection enabled status (Bank/Function display flashing) to select the
new bank number, and repeat the above operation.
Operation Chapter 3
To Next Page
Loading...
